Menu
Home
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Members
Log in
Register
Search
Search titles only
By:
Search titles only
By:
Current visitors
New profile posts
Search profile posts
Search
Search titles only
By:
Search titles only
By:
Menu
Home
Members
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
seasick's latest activity
S
seasick
replied to the thread
94' ish 209 escape access hatch
.
The spec for the access plate is the opening size not the outermost measurement. In your case it looks like a 6 inch model. Here is a...
Apr 25, 2024
S
seasick
replied to the thread
282 Sailfish - Water in fuel!?!?
.
In this specific thread, the OP boat has a combo fill/vent fitting. There is no outside clamshell
Apr 25, 2024
S
seasick
replied to the thread
Fuel tank sender gasket
.
Measure the diameter of a circle that lines up with the holes. If that measurement is 2 1/8 inch your gasket is a standard SAE 5 hole...
Apr 24, 2024
S
seasick
replied to the thread
282 Sailfish - Water in fuel!?!?
.
Years back I left the gas cap on the gunnel off. We have a horrific rain storms for a couple of nights so to cover all bases, I pulled...
Apr 24, 2024
S
seasick
replied to the thread
27 Islander Garboard Plugs
.
Most likely the other two are spares
Apr 24, 2024
S
seasick
replied to the thread
Fuel tank sender gasket
.
It is a standard item. Any marine store would have one assuming it is the round one with five holes. Here is a West Marine sample...
Apr 24, 2024
S
seasick
replied to the thread
282 Sailfish - Water in fuel!?!?
.
A few years ago, I was asked to look at a boat that was recently launched for the season but broke down during the first trip. The motor...
Apr 23, 2024
S
seasick
replied to the thread
Yamaha 115 4 stroke sputter/stalling. Help!
.
Good plan. One comment though; The clear bowl on the gas filter (motor mounted) should not be full. If it is, you may have an air leak...
Apr 22, 2024
S
seasick
replied to the thread
Lithium battery size for trolling motor
.
What is your plan for recharging?
Apr 22, 2024
S
seasick
replied to the thread
282 Sailfish - Water in fuel!?!?
.
Most of the things you did were fine. Two things were not 100% correct. The first is in general you should not use sealant on the sender...
Apr 22, 2024
S
seasick
replied to the thread
Yamaha 115 4 stroke sputter/stalling. Help!
.
My bad.I did look up 2 stroke.. In this case, ignore my comments. I would definitely measure fuel pressure output at the VST first as...
Apr 22, 2024
S
seasick
replied to the thread
Yamaha 115 4 stroke sputter/stalling. Help!
.
I strongly recommend that you get a genuine Yamaha pump. There are some garbage pumps on the aftermarket world. The Yami pump is not...
Apr 22, 2024
S
seasick
replied to the thread
282 Sailfish - Water in fuel!?!?
.
How did you test for water in the fuel? How did you filter the tanks? The most accurate way to check for water is to pull the sender and...
Apr 22, 2024
S
seasick
replied to the thread
Yamaha 115 4 stroke sputter/stalling. Help!
.
Not easily. If it has never been replaced, it probably is time... I see there is only one for your motor part number 6E5-24410-10-00 If...
Apr 22, 2024
S
seasick
replied to the thread
Hydraulic steering problem
.
It could take a while. It all depends on how small or large an internal leak there is. One trick to avoid having to hold the wheel for...
Apr 22, 2024
Home
Members