seasick's latest activity
-
Sseasick replied to the thread New Batteries.I am not so sure it is the switch. One battery worked before you replaced both batteries and now neither works? Turn the switch to BOTH...
-
Sseasick replied to the thread 12v or 24 system.Well at least you are not crazy
-
Sseasick replied to the thread New Batteries.There should be a battery cable connecting the negative terminals of both batteries together. You may have left it disconnected.
-
Sseasick replied to the thread 1999 Yamaha XO 66 250 Service Manual.I have an electronic copy of the S250 1999 manual. If you post or message me with your email info, I will try to send it. The file is 12...
-
Sseasick replied to the thread 1999 Yamaha XO 66 250 Service Manual.Is that the correct model number?
-
Sseasick replied to the thread 8 original hours on 2008 GW and Yamaha 200 questions.My advice is to spend most of your time looking for issues with the hull and mechanical things and assume that the engine has major...
-
Sseasick replied to the thread ignition protection.One thing not mentioned is that the new motors may draw more current than the old motors did when cranking. In that case, it is possible...
-
Sseasick replied to the thread ignition protection.The issue is voltage drop on the accessory buss. That can be related to many things, the more common being weak batteries (a load test...
-
Sseasick replied to the thread Battery Conditioner Recommendations?.I should mention that whatever source you connect to for power to the charger should be ground fault protected for your safety. If you...
-
Sseasick replied to the thread 300 with 2 mfd.Is the boat a Marlin 300? If so, what year? Based on what I have seen for newish years of Marlins, two 12 inch screens will fit. I don't...
-
Sseasick replied to the thread Does the 300 model have a drain in the anchor locker.I would expect a drain. Typically there is either a hull drain out the side or direct drain to bilge. If the former, you should see a...
-
Sseasick replied to the thread Transom thru hole.Save the old gaskets and use them with the new ones to add some space between the flop and the tube edge.
-
Sseasick replied to the thread Battery Conditioner Recommendations?.Here is a NOCO receptacle, that accepts a plug from the charger(no cutting the plug off). The unit is basically water proof on the...
-
Sseasick replied to the thread Seaport Blue.Is the hull gel coat or is it paint?. I suggest you call Grady support and tell them your problem. The whitish stains are odd but may be...
-
Sseasick replied to the thread Gel coat repair 228G 1994.You didn't say if the areas were smooth or if they are non skid. The later is more difficult to repair but it is possible to replicate...