SkunkBoat's latest activity
-
SkunkBoat replied to the thread New digs for my Seafarer!!.If I had that shed I'd be painting the epoxy cote on the bottom of my boat and be fishing by April. but I'll be waitng for May weather... -
SkunkBoat replied to the thread Shorepower breaker.Its a 30 A breaker and an ELCI or a GFCI. It is protecting the inlet power to the boat. I'm pretty sure all ELCIs are 2 pole breakers...
-
-
SkunkBoat replied to the thread Shorepower breaker.Take cover off to get model. Look on Blue Seas site for ELCI/GFCI breaker
-
That is stupidly ridiculous... and I'm jealous ;)
-
Just went through a big life change after 36 years,,,,, but enough of that. Bought a new place for my boat and for my next chapter in...
-
SkunkBoat replied to the thread Rubber hose for cooler drain?.Sometimes drains can be unscrewed from inside the cooler. Then you can just bend the hose towards you, pull off the hose barb, install...
-
SkunkBoat replied to the thread Rubber hose for cooler drain?.Thats a drain. its not below the waterline. But it is at the waterline so don't go cheap... You can use several of the available hoses...
-
SkunkBoat replied to the thread Battery runs low on anchor.Looks like all the heavy loads are on the Port bank. Windlass, thruster, power assist pump. They will run batteries down quickly if...
-
SkunkBoat replied to the thread Battery runs low on anchor.its a pdf not an image? jpeg, png Here's a screenshot png
-
-
SkunkBoat replied to the thread Battery runs low on anchor.define "Electronics" VHF(s), MFD(s), sonar, radar? How many batteries? No 2500w stereo? No refrigerator? No AC? No pumps running? No...
-
SkunkBoat replied to the thread Tidal Slip Equipment.heheh East coast...twice a day.... That slip looks like its for a 17 whaler or a Carolina skiff I don't think I would do that with a...
-
SkunkBoat replied to the thread Fuel Tank Replacement.Hoping is not an action plan;) There is a 6" piehole over each end of the tank. Look at it. I think you should remove whatever deck...
-
SkunkBoat replied to the thread Mold cleaner recommendations for caulking.Home Depot, Lowes
-
SkunkBoat replied to the thread trim tabs anodes.there is just enough room for an R3 in the "pocket". It has to be bumped right up to the bend up on the rear of the tab. I don't use...
-
SkunkBoat replied to the thread trim tabs anodes.Mine have a zinc R3 on them. Like others, I started using 1/2 the set on each tab.(mount on top) They always get eaten up. For some...
