SkunkBoat's latest activity
-
Also, closely inspect the connections - really close. A multimeter is good, but it doesn't tell you if enough amperage is flowing... -
SkunkBoat replied to the thread Thru Hull ID.It looks like you have an Airmar B744V "triducer". It has a paddle wheel for speed? They require a 2" hole. The direct replacements...
-
SkunkBoat replied to the thread New Batteries.Check the connection of the "motor to battery" or "Starter" cable. The Neg will be connected to a battery and the Pos will be on the...
-
SkunkBoat replied to the thread Grady White Chase 263 transducer mounting.Hard to tell with the paint ..It looks like you have an Airmar B744V "triducer". It has a paddle wheel for speed? Its mounted on flat...
-
SkunkBoat replied to the thread ignition protection.It has electronics that control a RELAY that Combines (makes parallel) the batteries when there is a charging source(running motor). It...
-
SkunkBoat replied to the thread ignition protection.idk what the mechanicalal key/start is like. On my fly by wire, the KEY does not have a start position, just an ON position. There are...
-
SkunkBoat replied to the thread 265 Express Dash suggestions.Exactly!
-
SkunkBoat replied to the thread ignition protection.Go on blue seas site and look at the diagram and instructions
-
SkunkBoat replied to the thread 265 Express Dash suggestions.I pondered doing something with the bubble and after a half assed assesment determined it was more trouble than its worth. I'm pretty...
-
SkunkBoat replied to the thread ignition protection.If the house is separate from starting batteries, then starting motor cannot effect the House 12v. Separate your 12V House from the...
-
SkunkBoat replied to the thread Transom thru hole.Sometimes they stay open a little until water pressure closes them but they should not be pushed out by the tube
-
SkunkBoat replied to the thread Transom thru hole.Cut the old flap off and use as a gasket to extend it out. Thats what I did
-
SkunkBoat replied to the thread 330Express Transducer question.I think your GT51m will do great for bottom fishing and as your everyday go to. The GT51 will read depth for tiles in 450-600. That'll...
-
SkunkBoat replied to the thread Circuit Breaker.If I remember right, the red button has small philips screws and ring terminals, like #10. IMO too small for 6 gauge wire. Get yourself...
-
SkunkBoat replied to the thread Circuit Breaker.Probably your 40A 12V House breaker. Your manual should show it. Disconnect the wire and see what doesn't work. Red button breakers...
