Search results

Could someone please identify the transducer on the right on my ‘98 Adventure? Thank you. Bob in Biloxi

SkunkBoat - Thanks so much for your suggestions. They were key to my fixing this problem Today I posted a short story to this thread on what I did. Thanks again. Bob in Biloxi

Thank you Hookup1. Your reply about the water pressure was spot-on. I just posted to this thread how I eventually "fixed" my problem, thanks to folks like you. Bob

Thanks, all. MY 94 YAMAHA 200 2-stroke did not come with a flush port. That sounds like one of those fancy, new-fangled modern devices many of you must have! Bob

Thank you, Seasick. Your suggestions were right on. I just posted my successful fix for the motor and it had everything to do with getting adequate water through the lower unit up to the pump to get that new pump primed. Thanks again. Bob

Thank you for all of the ideas and suggestions for helping me figure out why my 1994 Yamaha was not discharging water out of its pee hole when it was running. Due to your help I WAS ABLE to get water out of the pee hole FINALLY. When I first acquired the boat a short while ago I brought it...

Thank you, PointedRose - I do believe that I have that key in properly but I will ensure that it's in correctly if I have to take everything apart again. Bob

Thank you again. I appreciate all of the ideas. Bob

Great idea. Thank you. Bob

Thank you for the reply. Tomorrow i am going to do what several of you are suggesting and before I take the lower unit out again I will fill up a tub and see if that works. Bob

Thank you, SmokyMtnGrady - I will definitely look at that. Bob

glacierbaze - I was not able to test anything on this boat or motor before acquiring, but when I started the motor a couple of weeks before we had what we call a cold spell here in Mississippi, the pee hole was spitting out water fine. After the cold spell (temps got down into the 20s here) I...

DennisG01 - You are correct in your first paragraph but I don't think the amount of water squirting out did change by a noticeable amount once the motor was running, but I will confirm that. I let the motor run for only three or four minutes before shutting if off due to not seeing any...

freddy063 - Thank you for the idea. I will check that when I drop the lower unit again. I did install a new water pump housing cap when I put in the pump repair kit but I can see how easily it would be to not form a tight fit with the water tube when installing the lower unit. Thanks again. Bob

Thank you, SkunkBoat. I am running on a new set of ears. I will try the tub idea first and then I will try your idea of taking the lower unit back off and directing water into the water tube to check for obstructions if the tub method fails me. Bob

Dear Fellow Forumers - My new-to-me 1994 Yamaha 200TXRS (2 Stroke) is not spitting any water out of its pee hole. I have replaced the old rubber water discharge tube, installed a water pump rebuild kit with new housing and impeller, and snaked the metal water discharge tube with a stiff wire as...

To easily remove old vinyl stickers from your boat's surfaces (fiberglass, glass, whatever) without harming the substrate or gelcoat, get yourself a 3M Stripe Off Wheel. Attach the rubber wheel to your drill, slowly apply pressure from the spinning wheel to the offensive sticker and watch the...

Thank you, glacierbaze, seasick, and Dennis. I do not know the reason why the oil injection system had been taken out, but your advice will help keep this new-to-me boat and motor propelling forward, and occasionally backward. Bob

Thanks, Dennis. Would you recommend a 50:1 fuel:oil ratio? Bob

Thank you for the information. The motor is a 2 stroke. I will definitely research this issue further before taking the boat out. Dennis - thank you for the reply. I think seasick is correct - a former owner has removed the oil tanks, there is also no oil reservoir under the 2 cycle motor's...