Ran new AWS12 wire from back of old stereo in 330 Express to behind the panel. I’m upgrading to new Fusion stereo and thought I’d run new wire since I was running NEMA and new speaker wires.
Anyhow, I pulled panel and hooked up NEMA 2000 to fuse block on back wall. I’d like to tie in to stereo switch in panel which has a 10 amp fuse. I see where the positive wire goes but where do I connect the negative wire and ground? Do I even need the ground?
Attached is where I think I need to attach the positive and negotiate wires. Is this correct?
Anyhow, I pulled panel and hooked up NEMA 2000 to fuse block on back wall. I’d like to tie in to stereo switch in panel which has a 10 amp fuse. I see where the positive wire goes but where do I connect the negative wire and ground? Do I even need the ground?
Attached is where I think I need to attach the positive and negotiate wires. Is this correct?