transom degrees, bracket degrees info
- Thread starter merc663
- Start date
1). On the trailer, adjust the height of the bow so that your keel is exactly level.
2.) Take a level and hold it vertically up against the transom at the top of the splash well and hold it perfectly plumb.
3.) Have your helper take a sliding bevel and match it to the transom and the level.
4.) Transfer the angle to a piece of paper and measure with a protractor.
There are probably many ways to do it, but this is what came to mind. Good luck!
2.) Take a level and hold it vertically up against the transom at the top of the splash well and hold it perfectly plumb.
3.) Have your helper take a sliding bevel and match it to the transom and the level.
4.) Transfer the angle to a piece of paper and measure with a protractor.
There are probably many ways to do it, but this is what came to mind. Good luck!
If you go on the Armstrong site there's a form that shows you. It's the same for any bracket manufacturer. I purchased from a different supplier.
https://www.armstrongnautical.com/wp-content/uploads/2019/01/Bracket-Info-Form.pdf
https://www.armstrongnautical.com/wp-content/uploads/2019/01/Bracket-Info-Form.pdf