seasick's latest activity
-
Sseasick replied to the thread Cabin cushion covers in the washer.I wouldn't dry them in the drier at all unless there was a care tag that said the dryer was OK to use
-
Sseasick replied to the thread fuel and spedo guage not workin.Ditto to what has been said, adding the question; " Do the gauges power up and go through the initial self test?" When you say that the...
-
Sseasick replied to the thread Freedom Trim.And why is that a problem? What's more important to determine if the set up is working is knowing the WOT revs, adjusting engine trim...
-
Sseasick replied to the thread water spots on my 1991 228 windshield.If mineral deposits are left on the glass for long periods and exposed to sunlight, the minerals will etch into the glass and bond to...
-
Sseasick replied to the thread horn and radio.Horns go bad all the time, work on that last. Which radio, VHF? You need to take a look at the back of the radio and find the power and...
-
Sseasick replied to the thread Sending Unit for Tournament 192.Unfortunately, I am having more of those lately.
-
Sseasick replied to the thread Sending Unit for Tournament 192.At least I know that my posts are read. Did I say pickup??? Oops.
-
Sseasick replied to the thread Need new cabin cushions for 2003 Grady White 2088.There are four cushions for the 208 cabin: Port and starboard 'soft' cushions. Each side has different dimensions. The over the porta...
-
Sseasick replied to the thread Transom Leaking.It may be a bit late. It is possible that the coring is soaked or that the glass has delaminated leaving a space for water to collect...
-
Sseasick replied to the thread Transom maintenance.You must have better luck than I do, I have often broken off SS screws on motor parts, like brackets, anodes, ground lugs etc.
-
Sseasick replied to the thread Electrical problem of the day.Try a test lamp with an incandescent bulb and see if it lights when the test tip is touched to the 12 feed lead. Then move along to the...
-
Sseasick replied to the thread Electrical problem of the day.The high voltage is measured wit the fixture n the ON state would indicate a bad ground.
-
Sseasick replied to the thread Transom maintenance.If they used SS bolts and washers on aluminum plate without some sort of sealant as an insulator , there will be corrosion issues ...
-
Sseasick replied to the thread 12V Circuit Breaker Tripping for Fresh Water Pump.There may be a problem with the switch. It may have something internal that shorts the power to ground when in the off position. I...