Search results

Try this link for a Moeller Marine Sending unit. $23.95 at Amazon.http://www.amazon.com/Moeller-Marine-El ... B000MTI15K That's what is in my tank.

I am in the process of replacing the fuel tank in my 83 Tournament 19. When I removed the 1 1/2" fill line from the fill nozzle, I found a bare wire sandwiched between the hose and nozzle. It did not look like a Grady installed wire. The wire appeared to be ultimately connected to the negative...

Toolguy, Thanks for your reply. I will see if I can get to the drain pipe by reaching through the 6" deck plate in the engine well over the bilge. Do you agree that the fuel tank hatch should remain dry? By the way, the tank is original to this 83 Tournament.

I trimmed the front flange and was able to remove the tank.There was a great deal of debris on the bottom of the hatch. When I unglogged the drain, I was surprised to see that the hatch would not completely drain. I put a fiberglass rod through the drain pipe. It went into the bilge and exited...

GW204 Thanks for your rapid and very thorough reply. You even answered one of the questions I forgot to ask. As I look at the length of the tank and the size of the opening, I could not figure out how the tank could come out. Trimming the forward flange, which is about 4 inches wide, should...

While winterizing my 83 Tournament 19, I found water in the fuel. I drained about 5 gallons from the tank before getting all fuel. When I tried to top off the tank, I noticed that when the level reached the top of the filler neck, it would soon disapear. I pulled the tank hatch and found the...

Wiper arm I found what looks to be a spring release tab on the bottom of the arm. Even though I soaked the assembly with penetrating oil and pulling out the release, the arm would not budge. However, it turns out that the tip of the arm has an adjustment for the angle of the wiper blade which...

Windshield wipe George, Thanks for your reply. Can I just pull the arm off the spline or is it secured somehow? Leigh

The rest position for the wiper on my 1983 Tournament 19 is too far to the starboard side which carries most of the wiper off the windshield. Can the wiper arm be repositioned? If so,how? Is there another fix? Thanks in advance

Image stabilized binoculars The Canon stabilized binoculars are nice but not waterproof. I read several reviews where the stabilization system stopped working after a year. The presumption was that the salt water envioroment was the cause. The Nikon Stabileyes are waterproof but cost more than...

Workdog, Just got off the phone with Frank at Amishoutfitters. Based on his recomendation I ordered 2 22 inch Beefy Bags. Very nice and helpful gentleman. Thanks for your input

I'm going to do a little trolling this year and would rather avoid putting a kicker on my Tournament 19 with a 2 stroke 155hp commercial Evinrude. Would like some pro/con comments on using a trolling plate.

Bob P, I have a Garmin 545S plotter/sounder. Garmin makes a flow transducer that will integrate with the GPS. The transducer is NEMA 2000 while my plotter is NEMA 0183 so the interface is through Garmins CANet protocall and seems a little fussy to set up. Street price for the transducer and...

Bob P, I learned the hard way that my fuel gauge/sending unit is not linear.I am trying to get a handle on remaining fuel after running for a while. I may install a fuel flow transducer to interface with my chart plotter.

My 1983 Tournament 19 is powered by a 1989 Evenrude 155 commercial. The engine runs well and has good compression in all cylinders. Does anyone care to speculate what my average fuel consumption in gal/hr should be? Leigh

I need an Owners manual and wiring diagram for a 19 Ft Tournament. I tried downloading a manual from the GW website but got no where. I tried following their instructions but kept going in circles. Any ideas for other sources?