2003 Chase 263 helm modification

KlienfeldChase273

New Member
Joined
May 30, 2024
Messages
2
Reaction score
1
Points
1
Age
46
Model
Chase
Good morning all.
I’d like to remove the stainless steel handles alongside the collapsible electronics cabinet to accommodate two 12 inch flush mount simrad evos.
has anyone ever removed those? I don’t see a mounting point below the cabinet nor do I see a connection from the head where my batteries are stored (directly beneath this collapsible cabinet).
I hate to take a grinder to these and damage my gel coat so I’m looking for any help.
Thank you in advance.
 

Attachments

  • IMG_3158.jpeg
    IMG_3158.jpeg
    568 KB · Views: 30

loubeer

GreatGrady Captain
Joined
Sep 6, 2017
Messages
204
Reaction score
75
Points
28
Location
Newport Beach, CA
Model
Express 330
If like my 330, you'll have to raise electronics closure, disconnect ram, lower ram, prop up electronics closure fully, remove tub and you should be able to access handle/disconnect mounting screws.
 

Sardinia306Canyon

GreatGrady Captain
Joined
Oct 11, 2023
Messages
523
Reaction score
101
Points
43
Age
60
Location
Island of Sardinia
Model
Canyon 306
If like my 330, you'll have to raise electronics closure, disconnect ram, lower ram, prop up electronics closure fully,
Yes, would be the same on mine, i have a pin to pull (and insert later) who connect the ram and the closure.

I have rather long and normal thick hands and it's not easy to reconnect the ram as space between electronic enclosure and console is very tight, doing it in 2 persons will probably easier.

I’d like to remove the stainless steel handles alongside the collapsible electronics cabinet to accommodate two 12 inch flush mount simrad evos.
Your console look considerable smaller than mine so two 12" units would not stay on the original panel.
My fantasy is momentary a bit limited, can you explain what the handles have to do with installing two 12" MFD's?
Do you want to make the electronics enclosure wider, close it shut or leave the box always open?

Chris
 

DennisG01

GreatGrady Captain
Joined
Sep 1, 2013
Messages
7,188
Reaction score
1,341
Points
113
Location
Allentown, PA & Friendship, ME
Model
Offshore
Those handles are simply thru-bolted - access the underside for the nuts. Looking at your picture, you likely have a couple options. 1) As noted above about removing the electronics tub. 2) On the port side, remove that small cubby below the handle... is there another cubby on the stbd side?

IF there's no access by removing the cubbies, is anything removable in the head like a headliner? Otherwise, you're back to the tub.