200hr service

dogdoc

dogdoc

Well-Known Member
Joined
Apr 23, 2019
Messages
395
Reaction score
79
Points
28
Age
70
Model
Marlin
Getting ready to do first 200hr service. Will do all the R's. There is a lot of I/inspect in the chart. I will service the impeller but of the other"I's" any suggestions.
thanks
 
There's lots of different engines out there... different brands, old, new, 2-stroke, 4-stroke, etc. If you can list the checklist you're referencing and the specific engine, that would help! :)
 
whoops df250 the ones skunk boat says have am radio and roll up windows!
 
dogdoc said:
whoops df250 the ones skunk boat says have am radio and roll up windows!
Click to expand...
I don't think the maintenance is any different on the mechanical motors except I would inspect the shift & throttle cables and grease the linkage.
Maybe empty the ash tray and see if the lighter still works...

a picture of the page in the manual would help.
 
I would replace the internal anodes. If you are going to look at them , might as well replace. You need new o-rings and I would have a spare screw too

DF200 maintenance_2021_2.jpeg
 
pic from my manual

zuke maint.jpg
 
With that list, everything seems to be pretty mundane and ordinary - all common things to inspect on a regular basis. Was there something that has you worried?
 
was hesitant about internal zincs until saw a video of a 200hr service, now very inclined to change them out and give block a good flush. having never done it not sure if it could be done on the lift at next 100hr (300 total) so figure i will give it a go this pull, then not have to worry till next pull at 400hr.
 
You must log in or register to reply here.