'95 Islander Seatback Removal

'84_241_Offshore

Well-Known Member
Joined
Jun 26, 2018
Messages
71
Reaction score
5
Points
8
Anyone know how the rear seatback on a '95 Islander is installed?
Is it the same as the bolsters20231209_133355[7611].jpg20231209_133347[7610].jpg? See Pics.
 

Hookup1

GreatGrady Captain
Joined
Oct 16, 2007
Messages
3,035
Reaction score
855
Points
113
Age
70
Location
Cape May, NJ
Model
Islander
Mine lifts straight up. Run something along the bottom edge (bent piece of sheet metal) to look for snaps.

Companion seat is the same too but it has snaps
 

'84_241_Offshore

Well-Known Member
Joined
Jun 26, 2018
Messages
71
Reaction score
5
Points
8
Mine lifts straight up. Run something along the bottom edge (bent piece of sheet metal) to look for snaps.

Companion seat is the same too but it has snaps
Are you referring to the "Passenger Seat" when you say "Companion""
Mine was held in with screws/bolts............
 

'84_241_Offshore

Well-Known Member
Joined
Jun 26, 2018
Messages
71
Reaction score
5
Points
8
Yes. I have a wraparound passenger seat.
As I stated above, mine was installed w/ screws/bolts.
I'll be looking for snaps on the bottom of my rear seatback tomorrow, thanks.
It moved only slightly when I tried lifting it straight up.
 

Hookup1

GreatGrady Captain
Joined
Oct 16, 2007
Messages
3,035
Reaction score
855
Points
113
Age
70
Location
Cape May, NJ
Model
Islander
As I stated above, mine was installed w/ screws/bolts.
I'll be looking for snaps on the bottom of my rear seatback tomorrow, thanks.
It moved only slightly when I tried lifting it straight up.
If to look at the seat back you can see two snaps - one inthe right corner and one next to the left hinge. The backrest was redone and snaps eliminated.
IMG_0320.jpeg
 

'84_241_Offshore

Well-Known Member
Joined
Jun 26, 2018
Messages
71
Reaction score
5
Points
8
If to look at the seat back you can see two snaps - one inthe right corner and one next to the left hinge. The backrest was redone and snaps eliminated.
View attachment 32037
Thanks for the reply & pic.
Looks like your seatback was lower than mine, my seatback doesn't go below the hinges like yours.
Still going to check for the snaps.
 

'84_241_Offshore

Well-Known Member
Joined
Jun 26, 2018
Messages
71
Reaction score
5
Points
8
Mine was installed w/ 1/4-20 through bolts & fender washers.
Not sure if this was from the factory, not too pretty...

20231210_100438.1.jpg20231210_101403.1.jpg20231210_101409,1.jpg
 

Hookup1

GreatGrady Captain
Joined
Oct 16, 2007
Messages
3,035
Reaction score
855
Points
113
Age
70
Location
Cape May, NJ
Model
Islander
Mine was factory. Apparently earlier versions were not as elegant. Good luck
1