Accessory Switch Wiring

[13rounds]

I have a 2000 208 Adventure and my girlfriend bought me some underwater lights. The switch panel has 4 accessory switches that have been prewired. One is connected to my raw water wash down and I found one of the wires for the switch in the back that I connected to my livewell pump. Does anyone have any idea where the remaining 2 are?

 

[ElyseM]

You should be able to see that from the manual. If you don't have one go to the GW site and pull it down. If this was done by a prior owner, could be anything. Also, they could be blank. All of the switches are pre wired, but they may not be attached to any load. I had a couple on both boats. All you have to do is pick up the hot side and run to the load. Good luck, Ron

 

[13rounds]

Thank you. It was prewired and was laying in the back