Battery charger issues

jigstrike

Well-Known Member
Joined
Apr 12, 2015
Messages
59
Reaction score
8
Points
8
I hauled out my marlin in December, and am starting to do some work on her. I have her plugged into shore power, but whenever I turn on the battery charger breaker switch, the ac panel switch flips off.
Was working fine a couple months ago.
Ideas???
Thanks!!
 

seasick

Well-Known Member
Joined
Aug 19, 2008
Messages
9,531
Reaction score
1,420
Points
113
Location
NYC
You either have a short in the ac side wiring to the charger or the charger itself is fried.
I assume that other switches on the AC panel work. Is that so?
In any case, you will have to take a look at the charger wiring to see if there is obvious damage. You may also want to undo the AC panel and look for a short ( maybe, a bugs nest or corrosion) around the breaker wiring.
 

SkunkBoat

Well-Known Member
Joined
Oct 12, 2017
Messages
4,508
Reaction score
1,614
Points
113
Location
Manasquan Inlet NJ
Website
www.youtube.com
Model
Express 265
Do you have any problem with anything else in an AC receptacle on your boat? Microwave? Plug in a light or a drill...

What brand /model charger? Sealed unit?
find where the AC wire connects to the charger.
Is it a plug or screw terminals or butt connectors?

depending on your charger, you may be able to disconnect from boat AC, put a standard AC plug on the charger's AC wire and test it on your house AC ( like a gfci outlet in your garage using an extension cord)
If ok, test it in a receptacle on your boat
 

Fishtales

Well-Known Member
Joined
Jan 31, 2005
Messages
8,033
Reaction score
1,286
Points
113
Maybe a weak breaker if you don't find something else if happening with a load applied and the inrush current trips it.
 

seasick

Well-Known Member
Joined
Aug 19, 2008
Messages
9,531
Reaction score
1,420
Points
113
Location
NYC
If there is a weak breaker it will show when you plug in or connect any AC device with a similar or greater current draw. A heat gun or hair drier will draw a lot more current than your charger would. I thing your charger probably draws about 300 watts or so.
 

jigstrike

Well-Known Member
Joined
Apr 12, 2015
Messages
59
Reaction score
8
Points
8
just finished removing the old battery charger. It is a corroded mess!!
It is a Dytek model GP-1230-4b
Any ideas on the best replacement?
Thanks
 

Fishtales

Well-Known Member
Joined
Jan 31, 2005
Messages
8,033
Reaction score
1,286
Points
113
You need 2 banks min and prob 30A if you can get it.
 

Legend

GreatGrady Captain
Joined
Jun 29, 2006
Messages
1,462
Reaction score
201
Points
63
Location
Southern New England
Model
Sailfish
I replace mine 2 years ago with this model. My setup is two batteries in parallel and one single.
Guest 2722-B Crusing Series Marine Battery Charger (12/24-Volt, 30-Amps 15/15, Double Output)
 

Hookup1

GreatGrady Captain
Joined
Oct 16, 2007
Messages
3,035
Reaction score
855
Points
113
Age
70
Location
Cape May, NJ
Model
Islander
I just installed one of these. Waterproof and about $220.


If you want to re-use existing wiring ProMariner has a ProNautic series.
 

Fishtales

Well-Known Member
Joined
Jan 31, 2005
Messages
8,033
Reaction score
1,286
Points
113
Nice unit that will do the job for you...