Help Pros/Cons 2001 Voyager vs 2003 Seafarer

hattieice

Member
Joined
May 1, 2022
Messages
12
Reaction score
3
Points
3
Age
47
Hey all… new to Grady shopping and need some guidance please.

We are looking at the two models above. My questions revolve around capabilities between the 2 models. How far offshore? Ride quality and dryness of ride? Comfort of the cockpit? That type of stuff.

Seafarer has a 250 Yamaha with 834 hours.

Voyager has a 250 Yamaha OX66 hours not disclosed. Does have the transom with the metal on it so durability is a question.

Are there any big differences based on knowledge or experience as to what they can do or where they can go?

For reference we are downsizing and updating from an 87 Hatteras 40-footer. Thank you in advance. Appreciate your help and knowledge.
 

family affair

Well-Known Member
Joined
Jul 31, 2010
Messages
1,437
Reaction score
339
Points
83
Location
Ohio
Model
Islander
We had a Voyager for 10 years and put roughly 500 hours on an ox66 225.
It is a very dry riding boat. It has a tendency to ride bow high. The bow high characteristics has its pros and cons. The biggest pro by far is that when it gets nasty out you can slow down, pop the bow up and confidently plow through anything. The con being the boat can be tricky to trim at speed to cut through chop without pounding. It can be done, but the sweet spot is on the small side, so it takes practice. Get it dialed and you won't have much to complain about. To help out we added about 150 lbs of ballast to the bow, but the boat didn't have a hard top.
The added beam is nice - 8.5' vs 8' on the Seafarer. This gives a little more room between the seats. Also the cabin is taller on the Voyager - roughly 5'10" if I had to guess.
For water sports, I love the euro transom. For fishing, it requires more reach over the transom, but was never an issue. The Seafarer cockpit will be a little longer, but because of the narrow beam will have about the same square footage.
 

Fishtales

Well-Known Member
Joined
Jan 31, 2005
Messages
8,030
Reaction score
1,286
Points
113
All things being even, I'd go with the Seafarer. Newer boat. ox66 are thirsty and older. Without surveys it is tough to say.
 
  • Like
Reactions: Mustang65fbk

SmokyMtnGrady

Well-Known Member
Joined
Jul 11, 2009
Messages
2,020
Reaction score
504
Points
113
If they both were powered with the sane motor one or another , I would go bigger . They are not . The ox 66 is thirsty but they were done what bullet proof. The Journey is going to ride better but the layout of the 228 is amazing for a small boat . On a typical day of 2-3s either boat is fine but don't get me wrong , I wouldn't want to be 6 plus seas in either . I have been in 5-6 foot in the 228 and it's slow going . I didn't feel unsafe just don't prefer it if I am making any sense.
 

hattieice

Member
Joined
May 1, 2022
Messages
12
Reaction score
3
Points
3
Age
47
Thanks a bunch for that feedback. I’m trying to go best bang for the buck around $30k and in that sweet spot if 23-26 footers. but I’m no rush with the way the world is going.
 

Mustang65fbk

Well-Known Member
Joined
Jun 4, 2020
Messages
2,577
Reaction score
682
Points
113
Age
38
Location
Seattle area
Model
Seafarer
I actually just spent a little bit over a year looking for a 1998 and newer Grady White 228 Seafarer and finally found a 2004 back in Maryland this last October. I live just north of the Seattle area and it seems like everything out here is ridiculously overpriced, and that's especially true with boats. I bought my 2004 GW 228 Seafarer with a 2004 Yamaha F225 and with less than 1k hours as well as a 2009 aluminum I-beam trailer in fantastic condition for $26.5k. I then trailered her back home to the Seattle area with a rented U-Haul truck at 3,009 miles without any incident. My previous boat was a 21' Arima and I wanted a bigger, nicer, newer and more comfortable boat as the Arima would pound quite badly in the 1'-2'+ chop. For me, the 228 Seafarer is about the perfect boat for what I need it for, which is fishing, crabbing, cruising and so forth in the Puget Sound. The Puget Sound is protected and isn't the open ocean, so the conditions are usually pretty mild mannered but in October of last year I had the boat out in front of Edmonds with pretty decent winds and I'd say at least 5-6' waves. The boat handled great, I never felt uncomfortable or unsafe and is 100x the boat that the Arima was. The reasons for going with the 228 Seafarer were because it's a bigger, heavier, longer boat than the Arima, it has a deep vee, a more comfortable ride, it doesn't splash water over the front and sides like the Arima did and it's still decent on fuel economy. I love the enclosed transom with the transom bracket on the back, it has a ton of fishing room and I really like that the floor is all level, without any steps or stairs to trip or slip on. The cabin is a nice size, the cockpit and helm area are just fine and it's an all around fantastic boat. I've admittedly never been on or looked too seriously into a 248/258 Voyager because I honestly think it would be a bit overkill for my particular needs.

As stated above, the helm area is a bit narrow on the 228 Seafarer, but you can solve that issue a bit by taking the inner armrests off the seats to help being able to walk through more easily. I haven't done that yet on my boat but I plan to, as I'm about 6'2" tall and 265 lbs or so. The only other "gripe" that I have is that a little more fishing room wouldn't be terrible. The 228 Seafarer has 6 seats and going off experience with using my last boat, I don't think I'll use all of those seats very often, if at all. It would be nice option to be able to change up some of the seating options to allow for more fishing space. But then again, the boat does fish 4-5 people rather comfortably and I don't usually ever fish more than that. Just something that would be nice to have if you ever did need it. I do love having a 4 stroke motor and after going from my uncle's boat that had twin 2 strokes to myself owning 3 previous boats with 4 stroke motors on them, I wouldn't ever own another 2 stroke, unless the price was too good to pass up on. A buddy of mine has a boat with twin 2 stroke Etec's on it and they're loud as well as smoke quite a bit, and you have to have the oil reservoirs that you always have to check on. My 4 stroke is quiet, doesn't smoke and it does pretty decently with regards to fuel economy. Just make sure you have any early 2000's Yamaha 4 stroke checked out for the very common dry exhaust corrosion issue which several of them had/have. It's about a $2k to have fixed for you, and that's if the parts are even readily available. I always recommend that anyone who is seriously interested at looking or purchasing a boat to pay a surveyor to come out and look at it with/for them. Good luck with your search!


 

hattieice

Member
Joined
May 1, 2022
Messages
12
Reaction score
3
Points
3
Age
47
That is some solid and great info. I can’t imagine being out in too big a chop but I’m in the Gulf of Mexico and would really like to get out to some of that water. As well as someday maybe head towards the Keys or even Bahamas. So not sure if that would be doable in the 228.
 
  • Like
Reactions: Ky Grady

Mustang65fbk

Well-Known Member
Joined
Jun 4, 2020
Messages
2,577
Reaction score
682
Points
113
Age
38
Location
Seattle area
Model
Seafarer
If you're seriously considering a boat, I'd see if there are any local boats in your area or marina that maybe you could ask the owner if you can step foot on to see how you like the layout in person? Or if you made a friend with someone that owned one of these boats and chipped in for gas, maybe they'd take you out on the boat to see what the ride quality is like? Same with a potential local purchase and doing a sea trial run, as I always make a contingent offer based off of a favorable inspection as well as a sea trial run.
 

Don Davis

Well-Known Member
Joined
Mar 2, 2020
Messages
378
Reaction score
124
Points
43
Age
60
Location
Courtenay, British Columbia
Model
Seafarer
I was on a 248 about 6 years ago on a fishing trip and I couldn’t believe how smooth of a ride it was on the west coast of Vancouver Island at Nootka Sound in a 2 to 3 foot chop, velvet smooth. That trip started my quest for a Grady which I settled for a 228. The 1999 Grady brochure states that the 248 is 1000 lbs heavier and a little more beam the 228. The boat I was on had twin 130 hp Honda’s which were perfectly matched for that boat, you can’t go wrong with either model in my opinion. My 228 has a single 250hp Suzuki and is perfect for that hull.
 
  • Haha
Reactions: doug228

Ky Grady

GreatGrady Captain
Staff member
Joined
Mar 1, 2006
Messages
3,027
Reaction score
1,351
Points
113
Location
Berea, KY/Cross, SC
Model
Seafarer
That is some solid and great info. I can’t imagine being out in too big a chop but I’m in the Gulf of Mexico and would really like to get out to some of that water. As well as someday maybe head towards the Keys or even Bahamas. So not sure if that would be doable in the 228.
I trailer my 228 anywhere I want to go. SmokyMtnGrady and myself were in the Keys together last year with our 228's, he was in Key Largo and I was down in Marathon. We met up one day off Key Largo for some Mahi fishing, another day I went off Marathon to Mahi fish. Another day we hit some of the snorkeling sites together with both boats. Smoky has been over to the Bahamas with his 228, as well as the Dry Tortugas. The Bahamas is on the bucket list for me with my 228. The 228 will do alot of stuff very well for its size, although the old saying goes "There's no replacement for displacement", meaning sometimes bigger could be better.

20210513_132330.jpg2021_0512_12360600.jpg20210511_113420.jpg20210514_150537.jpg