Marlin Helm to Port Stereo Path

athomp228

Active Member
Joined
Jun 15, 2021
Messages
35
Reaction score
26
Points
18
Age
34
Location
Belmar, NJ
Model
Marlin
Anyone aware of a path from the helm to the stereo? Just installed a Fusion NRX remote at the helm and don't see an obvious path to the stereo location. Need to run a NMEA 2000 cable.
 

TortugaBob

GreatGrady Captain
Joined
Nov 16, 2018
Messages
102
Reaction score
31
Points
28
Location
South Texas
Model
Marlin
Did this a few years ago to run a new Remote from Helm to Stereo. Used a fishtape in Cabin Ceiling from Dome light, to Port Wiper Moto Cover, then around the side to Stereo. It was not intuitive, but worked fine. Kind of a Triangle. I could not find a good path from Bilge, Aft Berth up to Stereo.
 

athomp228

Active Member
Joined
Jun 15, 2021
Messages
35
Reaction score
26
Points
18
Age
34
Location
Belmar, NJ
Model
Marlin
I ended up snaking the cable down the starboard side where I was able to access inside of the aft panel in the berth, past the forward bilge, and followed the AC duct which went behind the microwave. Once I pulled the microwave out I was able to make a small hole to pull the cable into the window shelf and finally up into the back side of the stereo shelf.

Once complete, I realized how intuitive the Fusion phone app and watch app were. Nice to have but probably not worth it in the end.
 

brian bunk

Active Member
Joined
May 15, 2005
Messages
30
Reaction score
4
Points
8
Down through rigging hole
In electronics compartment,
Remove front panel in
Aft bunk, remove floor
In head compartment under sink,
Remove frig, hole behind
Microwave up through between
And shelvesmarlin cable route.JPG
 
  • Like
Reactions: franklink