Motor selection for Seafarer 22

tgcasey

New Member
Joined
Oct 31, 2011
Messages
2
Reaction score
0
Points
0
Hi
I am new to this forum and considering buying a Seafarer 22 set up with a bracket. It has no motor but I have a 150 Mariner with a 25" leg and I also may be able to get a 250 Mariner with a 30" leg.

My question is what is the best route to go? I am concerned that the 150 HP may be too small but I not sure what issues there may be with a motor with a 30" leg.

Comments? Suggestions? Recommendations???

Thanks

Tom
 

magicalbill

GreatGrady Captain
Joined
Aug 15, 2005
Messages
1,663
Reaction score
314
Points
83
Location
Indiana
Model
Marlin
Not sure about proper leg height, but I am certain that a 150 HP is too small.
I owned a Seafarer circa 1992 for 10 years and ordered a 250 for it. Great combo and plenty of power.
I would say a 225 would be good also, minimum 200.
 

Doc Stressor

Well-Known Member
Joined
Nov 13, 2009
Messages
1,186
Reaction score
295
Points
83
Location
Homosassa, FL
Model
Seafarer
Yep. 150 hp won't do it. 200 is minimal and 250 is just right for that hull.
 

Curmudgeon

Well-Known Member
Joined
Nov 30, 2005
Messages
875
Reaction score
1
Points
0
Location
NC/GA
I have a Tournament 22 with bracket and BF225/25". I wouldn't want anything smaller, and I got over carbs several motors ago ... :uhm
 

tgcasey

New Member
Joined
Oct 31, 2011
Messages
2
Reaction score
0
Points
0
Thanks.

Any comments on the 30" vs. 25" leg?
 

Grouper Duper

GreatGrady Captain
Joined
Feb 17, 2006
Messages
148
Reaction score
0
Points
16
Location
New Port Richey, FL
I owned one for 10 years, and had a 200 on it first and a 225 later. I loved it with the 225, and certainly wouldn't go below 200. The hull calls for a 25" shaft. You can't go shorter, but a 30" might work if you mount it on the highest mounts. Though I'm not a marine mechanic, I would think the only downsides would be a little extra drag and little deeper draft.

I also believe you can change middle sections on almost any outboard (maybe swap the 30" for a 25").

My current Grady has twin 200 HPDIs, and I think they're still a fantastic value on the used market. Find a low-hour, 25" unit that someone swapped for a 4-stroke, and it would be a great match for that hull. Light, powerful and efficient.
 

SwampGrizz

Well-Known Member
Joined
Oct 14, 2010
Messages
59
Reaction score
3
Points
8
I have a 200 Yamaha HPDI on my 2000 Seafarer 228G, and it's been a great engine. Just do a search on this board, and I believe the general consensus is that it's a good motor, just pay attention to clean fuel and clean filters. I bought it about a year ago with 186 hours on it, and so far so good. As far as power goes, I can't compare it to anything else because I haven't owned anything else like this, but it seems to get out of the hole OK, and it goes as fast as I want to go. I can see where a 225 or 250 might be a good option, but the 200 HPDI ain't bad. I would agree that 200hp would be a minimum. Good luck with your decision.
 

DB

Well-Known Member
Joined
Jan 22, 2008
Messages
149
Reaction score
0
Points
0
Location
Ocean City, Maryland
Grouper....that is no small job to replace the entire mid-section...done it...wouldn't want to do it again. :bang
 

hangman1176

Well-Known Member
Joined
Sep 13, 2007
Messages
70
Reaction score
1
Points
0
250 or stay home. LOL......... I sold mine and my next WILL have a 300 on the next 22-8.
 

GulfSea

Well-Known Member
Joined
Oct 23, 2010
Messages
198
Reaction score
1
Points
0
Location
Florida Panhandle
I have an F250 and absolutely enjoy it in every way. 200-225 would be fine too as others have said; you'll be disappointed with anything smaller. The real challenge comes when carrying more than 2 people with a smaller motor. Even the 250 takes a little bit to get out of the hole with 4 plus folks and gear onboard. Earlier than 2010 I think is only rated for 250hp but I would think the 300hp that the 2011's are rated for would be the real sweet spot.
 

Clockwork

Well-Known Member
Joined
Feb 7, 2011
Messages
110
Reaction score
0
Points
16
dads got a seafarer with twin 115s and it will actually plane on a single 115. the 150 would actually get er down the road but you wont be very happy with it. my overnighter (20 footer) has a 150 on it and its fine but tops at 32mph. a 22 footer is actually more efficient but that said i agree with the crew that 200 is your minimum that you'll be happy with.
 

SmokyMtnGrady

Well-Known Member
Joined
Jul 11, 2009
Messages
2,020
Reaction score
504
Points
113
I have an 08 seafarer and it came with a F250. I can see having the F300 would be awesome. I am intrigued about the twin 115 set up that clockwork mentions. I love to fish offshore and twins would awesome.
 

Dougiewestcoast

New Member
Joined
Apr 11, 2024
Messages
2
Reaction score
0
Points
1
Age
61
Model
Seafarer
Hi
I am new to this forum and considering buying a Seafarer 22 set up with a bracket. It has no motor but I have a 150 Mariner with a 25" leg and I also may be able to get a 250 Mariner with a 30" leg.

My question is what is the best route to go? I am concerned that the 150 HP may be too small but I not sure what issues there may be with a motor with a 30" leg.

Comments? Suggestions? Recommendations???

Thanks

Tom
Hey Tom, I have a 98 228 seafarer with An F250 Yamaha, it’s as small
As I would go.. full of fuel and 6 people you will
Struggle to get up on plane,, In my opinion.
 

Peter A

Well-Known Member
Joined
Jul 12, 2023
Messages
138
Reaction score
45
Points
28
Age
62
Location
New Jersey
Model
Adventure
I have an F200 on a 208 with hardtop, it’s good enough but I’d want more on a 228. HPDI 200 might be better but I wouldn’t put a F200 4Stroke based on my 208 experience with a smaller boat unless you run light, don’t have a hardtop and prop with a 4-blade.
 

blynch

Well-Known Member
Joined
Mar 2, 2021
Messages
104
Reaction score
52
Points
28
Location
Stamford, CT
Model
Seafarer
I'd hazard a guess that in the 13 years since this thread started he may have settled on a decision :p
 
  • Like
Reactions: Peter A