What is the consensus on treating the sand -like non skid sections on the gunnels? Do you wax/ polish it, or just clean it and put some Woody Wax on it.
Non Skid on Gunnels
- Thread starter bayrat
- Start date
I polish with Starbrite then wax with Trewax. Comes up great. I know it is non-skid but I rarely step on it, only to lower the VHF or store the rods for an offshore trip.
I treat it exactly as the rest of the gel coated surfaces. Polish with Finesse It and seal with Collinite wax. Creates a great shine that lasts for months. Surface is still not slippery after this process.
I use woody on it all the way to the rub rail. Do it every 2-3 weeks. Woody is so easy to apply i use it on the entire topside throughout the season.
Doc Stressor
Well-Known Member
- Joined
- Nov 13, 2009
- Messages
- 1,186
- Reaction score
- 295
- Points
- 83
- Location
- Homosassa, FL
- Model
- Seafarer
I use Starbrite non-skid deck cleaner on all of the cross hatched surfaces. It's not slippery and really lifts the dirt out. It seems to prevent stuff from sticking as well.
You can get the exact same product at Walmart under the Atwood label for a lot less money.
Everything else gets polished and sealed with a polymer sealant such as Woody Wax.
You can get the exact same product at Walmart under the Atwood label for a lot less money.
Everything else gets polished and sealed with a polymer sealant such as Woody Wax.
I use the Meguiare's three step on everything before the boat goes in the water in the spring and then maintain it with Woody Wax a couple of times during the season.