Nylon Snap Fasteners for 306 Windshield .

loafer-roatan

Active Member
Joined
May 30, 2012
Messages
34
Reaction score
3
Points
8
Anyone know where I can buy the nylon grommets for the male part of the snap fastener for the Isenglass?
 

Attachments

  • 15593223119852679952490368204681.jpg
    15593223119852679952490368204681.jpg
    1.7 MB · Views: 47
  • 15593223308067583318660349855600.jpg
    15593223308067583318660349855600.jpg
    1.9 MB · Views: 46

Fishtales

Well-Known Member
Joined
Jan 31, 2005
Messages
8,030
Reaction score
1,286
Points
113
I've never seen that fastener. Might want to either shoot GW Cust Service an email or see the dealer.
 

pat thai

New Member
Joined
Apr 5, 2019
Messages
4
Reaction score
0
Points
1
Age
60
Model
Release
Anyone know where I can buy the nylon grommets for the male part of the snap fastener for the Isenglass?
I has same problem you had would not find snap grommets .so far did you find any yet?
 

pat thai

New Member
Joined
Apr 5, 2019
Messages
4
Reaction score
0
Points
1
Age
60
Model
Release
any one know where I can buy the snap windshield rubber bushing for my Grady white 282 release.if yes I very appreciate it.
 

glacierbaze

Well-Known Member
Joined
Jul 6, 2012
Messages
2,488
Reaction score
644
Points
113
Age
75
Location
Chapel Hill and Pine Knoll Shores, NC
Model
Seafarer
Never seen that fastener. Can you show us a pic of one in place on the windshield. FWIW, it looks like it pulled out because the snap was corroded together. If there are more, I would put a knife blade between the 2 halves, pop them apart, clean and lube remaining fasteners.
 

DennisG01

GreatGrady Captain
Joined
Sep 1, 2013
Messages
7,189
Reaction score
1,341
Points
113
Location
Allentown, PA & Friendship, ME
Model
Offshore
I did call Grady white dealer ,because old model of my boats they don't make snap anymore.thanks you
I would check with them again and ask them to find out who the manufacturer is. Start with that - to see if they're even still made - before you go hunting around. You could also contact Grady directly and ask them.
 

glacierbaze

Well-Known Member
Joined
Jul 6, 2012
Messages
2,488
Reaction score
644
Points
113
Age
75
Location
Chapel Hill and Pine Knoll Shores, NC
Model
Seafarer
It's easy to make something work there, but it won't look the same. Take a male snap with a threaded stud on it, flat washer, regular nut inside the hole to keep it centered, flat washer on the other side, and a nyloc or cap nut.
Would still like to see a pic of a complete one.