Wiring

[Saltyone]

I was removing the rigging of my old motors getting it ready for the repower. We found this set of wires behind the storage compartment in the vberth that wasn't plugged into anything. It runs through one rigging tube, then back through another in the head area. Anyone have an idea. I've circled the wires.



Thanks

 

[Late Again Grady]

Do you have a remote spotlight?

 

[Saltyone]

Do you have a remote spotlight?

I don't

 

[cessna210g]

That looks like wiring for Bennett trim tabs.

 

[Saltyone]

That looks like wiring for Bennett trim tabs.

You're right, that has to be it. It might have got pulled back though when we were pulling cables.

Thanks!

 

[Saltyone]

Forgot I took a picture of the trim tab switch with the wiring. That's it.

 

[SkunkBoat]

Are you rigging the new zukes too or just removing the old yammie stuff?

 

[Saltyone]

Just removing the yamaha stuff. Took the motors off last weekend, just tidying up stuff

 

[SkunkBoat]

Just removing the yamaha stuff. Took the motors off last weekend, just tidying up stuff

looking at the first picture. You have the higher grade 1500 psi kevlar steering hoses. Do you have a Seastar Tournament Series steering cylinder(s)?
They are 1500 psi rated and they use different tie bars than the typical Seastar 1000 psi cylinders/hoses.

Just be aware you can't use standard hoses.

 

[Saltyone]

looking at the first picture. You have the higher grade 1500 psi kevlar steering hoses. Do you have a Seastar Tournament Series steering cylinder(s)?
They are 1500 psi rated and they use different tie bars than the typical Seastar 1000 psi cylinders/hoses.

Just be aware you can't use standard hoses.

I'm pretty sure I have just the standard Seastar, because it definitely doesnt look like the tournament series pictures I've looked at.

 

[SkunkBoat]

hoses look new. maybe PO replaced with the better hoses.