Recent content by zzzingpow

Yes my 2017 GW330 has shore power and gen set. When anchored or moored I run the generator for hot water, stove, etc I prefer 12v source for my daughter to watch videos with peace and quiet on deck

To dismiss without further inspection is foolish. Your life depends on your diligence in precautions hence: EPIRBS, radios, life vests, floatplans, firstaid kits, flares, etc ...negligence puts Coast Guard, Sheriff's, rescue personell at risk.

My Jensen is outdated, picture quality is lousy too. Anybody upgrade their 12v TV? I'm hunting for a quality 12v Samsung in 32" range but all I'm finding is Sylvox; any reviews or recommendations would be appreciated.

Great question, I'd like to know too.. Did your quote include new isinglass/ Clearview also?

Can I jump in here? I've a 2017 330express... ran my a/c for the 1st time last week. Cabin air functioned, water flowed as it should. Ran c/pit same time functioned good. C/pit however, when operating c/pit A/C alone I had no water flow?? Is this normal

No sir, the bell was installed by previous owner

Stainless actually.....

Finally finished the rod rack. Modified for access and lowered both, lower bar also tilts to allow Shurshade operation. Haven't put a blufin on board yet but Clemente bass, Catalina YT, LaJolla YT...no problem. Next week Tanner bank/ ridge for blueys...been rather windy last weeks

2025 model 330 accepts 425's. My 2017 330 has 350's; dealer said NO to 425's. Upgraded transom came about 2024....

Any chance you've better pics of rod rack? How do you reach them? Had a guy today measure for rack as yours in stainless however reaching rods is damn near impossible, lowering rack interfered with sunshade....I'm open for ideas

Very nice...love the rod rack. Definitely next on the to do.....just ordered new hub (got 2 just in case) out of west coast marine san diego be here tomorrow am. My rubber was chewed up innermost part. Thanks again for sharing the knowledge. See you on the water, ALI'I KAIA HuntingtonBeach,

WTF what?

You sir are correct. Spun port hub. Thank you, I didn't think of that. You saved me some $$$$

Your feelings are semi incorrect, previous owner did neglect however I had vessel surveyed and mechanically surveyed by yam tech prior to delivery, appreciate the input. Port prop hub spun starboard good to go

Put engines in gear starboard rocks back n forth approx 1", port spins free. THATS HOW TO CHECK. Remove port prop and perform exact as aforementioned process. Port shaft responds same as Starboard, Rick's back n forth approx 1"....spun hub it is....