Search results

Mine are fly by wire so no shift and throttle cables to deal with

There is tension adjustment on the shift lever. Google whatever shifter you have for instructions.

Seriously shark tank. I saw it on born again boating on YouTube . I have no plans of marketing anything. I just thought I would share a project .

Has anyone done this ? I figured while I’m at it might as well move the flusher from the motor to the boat to make it easier to flush. I added a 3/8 brass barb to extend the hose. Bought 3/8 reinforced hose ran it thru the rigging tubes and over to the battery side. There’s a place under the lid...

Best access to the wiring under the helm is remove the surround around the electronics box .

Very small flat blade screwdriver. Pry the caps off carefully.

I’m not trying to beat you up just saying heat is your friend when dealing with plastic. I have heated the end of a screw driver to cut through plastic to remove it if I have to . I think on the starboard side I removed both and replaced the outside fitting first. The inside one is going to be...

I used a heat gun to get the barbs out. They are plastic heat them up and shove a flat blade screwdriver in there and pry them out. A very little heat applied to the hose and shove it in the fitting after the fitting is in place. Make sure your clamps are slid on the hose and in the correct...

I just replaced them in my 330. Th marine I got original replacements

That white motor is looking good

Picture doesn’t do it justice. It’s just sitting up there. Looks really good . Will get better picks when I get it installed.

Survey the hull check for delamination around the rear vents on outside of hull. The 330 is a great boat. I’m on my second. I think 08 is when they changed the floor design in the cockpit. That’s the year I really wanted but found my 03 for a really good price. New power and new electronics won...

I had an 86 24’ offshore it had a single 200 Merc when I bought it . I switched it to a pair of 150 mercs. That was the best repower decision ever. Totally different boat with twins. I fished that boat for 13 years. It was a great boat

Here’s the finished product with blue backlighting. It’s finished being shipped out in the morning.

Busy day got all the steering reinstalled on the motors even the tie bar fit perfectly.

got them hung today now to start rigging

Boat outfitters . Com aka teak isle. They are right next door to my warehouses. Great bunch of guys.

Made it home with them now lots of wire pulling

Done except where the blocks and stands are. Heading to Stuart with a trailer in the morning to pick up motors and rigging. So excited can’t hardly stand it.

Enjoy the marlin is a great boat.