Search results

Good to know. thanks

You first need to find out what brands are available in your area. After that you can narrow down your options but note that these days the brand and model you decide on may not be available. On a separate note, I would not buy a Venture trailer. I have one and it had so many parts go bad in a...

I don't think your assumption that the sheen is from the fill and vent hoses is accurate. It's possible but so is a tank leak and maybe more probable. Some additional might help: First of all, old fill and vent hoses tend to become permeable as they age. That allows vapors to seep out before...

Excellent point. I wish I had thought of it:)

As I get older, I find that I am more interested in what is under the deck than above it. That's to say, easy access is a very important factor. That includes maintenance things like pumps, batteries, gen set access and everyday things like sea cocks. I haven't gone as far as checking scupper...

Do you tilt the other motor up when trolling on one motor?

Lots of variables. Hull type and shape makes a big difference. Basically at 2 to 3 knots, a hull is operating in displacement mode and drag is a function of surface area contacting the water, So if you want to know specifics, be specific in your question:)

or not:)

Unless there is obvious delamination detected by doing a tapping test on several areas of the transom, the only way to get an idea of the extent of the water is to have a moisture test done by a knowledgeable technician or surveyor. The bang cap looks pretty corroded but that doesn't...

If I am seeing this correctly, that is part of the transom and it looks quite bad. The question is how far the damage extends. It may be local to that area. I would guess that an impact or impacts to the rub rail caused a crack to open up and over time water continued to seep in. Obviously the...

I am interested to hear what you finally do and how it works out. You really can't do a 'complete' spider crack repair with the windshield frame in place and I don't recommend removing it unless absolutely necessary. If you can get some sealant into the holes and squished under the frame, that...

Boy did I misread the post. The issue is motor trim, not trim tabs... In both cases you need to check the oil level but the motor system does not self bleed in the same way that the trim tabs do. First step is to raise the motor, engage the engine stop lever, fill the reservoir with ATF fluid...

Usually a loose connection does not blow a fuse. Only an overload will normally do that. Your though that it might be a bare wire somewhere is possible but so is a short in a dash control, like the ignition switch or other devices powered from the motor harness. That might include a dash engine...

The Gulfstream is in a league of its own with other 23 footers. There is really very little comparison to the 208. The 232 is much bigger, wider and heavier. In many states, technically you need a permit to trailer due to its wide beam

How old is the boat? Those cracks are very common and may not be caused by the tightness of the screws. In can be the opposite. The metal frame of the windshield and the fiberglass mold of the helm expand and contract at different rates. That puts lateral stress on the screw connections...

The system if Bennett is self bleeding. After checking fluid level, cycle the tabs several times from one extreme to the other. That will bleed the system. In addition, on the reservoir there are two solenoids that have wires connected to each. They also probably will have a color mark, green or...

In some cases, vinyl cushions can be painted with spray paint that is intended for such an application. In this case the paint that has been applied probably has ruined the cushions. If you want to try to restore, I would use a citrus based paint remover (tested in a non conspicuous spot...

The 208 is a great 'compromise' solution for cruising and fishing. If you are not avid fisherpersons, it will be fine. If your wife needs a small cabin to change or use the porta potty, it will suit her needs. If she is tall or you are tall, the cabin headroom is not great. If your crew are...

The 208 is the same hull mold and my 208 does bow steer, mainly when crossing chop or wakes at small angles. Most of the time, my passengers just think I steered in different directions on purpose:) Actually, in rough seas you have to make compromises in trim to reduce pounding while also not...

Thanks for the info. !