Search results

Thank you for the confirmation. I am ordering the Garmin 50s and Airmar P66 today. Since I have the floor out and the rigging tunnel exposed it will be easier to run the transducer cable with little effort.

I was referring to the one rigging tunnel, molded in the hull which contains the following: Throttle, shifter cable 2 hydraulic lines for steering Positive/Negative battery power to engine Engine gauge harness There is lots of room in the tunnel for the transducer cable as well. This tunnel...

Is routing the transducer cable for a transom mounted transducer through the rigging tunnel, where the engine and battery cables run, a good idea?

Now because the cover is about 150 lbs, the rocking is not pronounced at all, just one corner is higher. The higher corner is just a few millimeters, enough to cause a slight flex. I have thought of using engineer's blue, same purpose as lipstick but the lifting of the cover and removing it...

Let me try again, sorry about the lack of clarity. Deck is the floor of the boat, covers the fuel tank. Also, the deck has a center console mounted on it, the depression is the area where the center console sits. Took the cover (deck) off to do some repairs. After repair on one corner it is...

Hello, I am sure some of you have come across situations where you are trying to mate two surfaces to sit flat against each other. I am looking for ideas on how to effectively make a deck, pretty stiff 1" thick piece of plywood cored fiberglass, on to a 2" ledge. Picture 1 is the deck turned...

Good work Dale. What is the green layer in this picture? Is this the floor cover, or fuel tank cover?

Thanks for the replies and helpful tips.

I am re-bedding hardware and need to drive screws, also I took the fuel fill hose fitting out, have to apply caulking there too. What is correct procedure to apply Life-Calk? Life-Calk I will be working in ~75F weather. I know to apply around the screw hole on the edge and then wait before...