Groco pump -simple macerator retrofit- 265 Express

SkunkBoat

Well-Known Member
Joined
Oct 12, 2017
Messages
4,521
Reaction score
1,619
Points
113
Location
Manasquan Inlet NJ
Website
www.youtube.com
Model
Express 265
I added a 1" elbow to the OUT port to prevent kinking of the clear tubing. ( I wanted a short piece of clear to see whats happening)
My setup is pumping liquid waste with no problems.
I calibrated the SCAD level sensor to indicate the correct levels.

Haven't had the pleasure of testing solids yet.
 

ttles714

Well-Known Member
Joined
Jun 6, 2009
Messages
214
Reaction score
16
Points
18
Location
NJ
If I recall correctly.... years ago, my 2001 Marlin .. I went thru the same situation .... After about half dozen times of dealing with the Groco , I was done with it !!! What idiot ever thought that set up was a good idea ??? My recollection is that top of the tank had one or two pipe threaded female fittings... I threaded a pvc pipe into the tank and it reached about an inch off the bottom... I connected a hose from that pipe to the inlet of a self priming maceration pump which I mounted to the stringer on the starboard side. I connected the original wiring and discharge hose to the maceration pump . This worked very well, ..My only regret was that I was too stupid to do it sooner !!!!
 

dogdoc

Well-Known Member
Joined
Apr 23, 2019
Messages
367
Reaction score
79
Points
28
Age
70
Model
Marlin
My boat is a 92 and in tank macerator and sensors did not work. I think it was 800$ for a new pump. Pulled the pump and put a small bilge pump in its place. Used a small section of pcv and adapters to original hose. Switched the in tank pump 12v supply at the cabin bulkhead panel. It is a #1 only system, anything more and its plastic bag time. We call it the ladies room. The 280 Marlin also has the self flushing head by the backdoor, preserving the how deep is it or how cold is the water jokes.