Search results

A multiport is more compact than a bunch of individual tees, if you are connecting several devices...

Another good place to look, the date of the last post before these two today!

All dressed up, with nowhere to go :(

I think that you would have to expect to through bolt them, to support the weight and the leverage from a pounding boat. Oh wait, it's a Grady White, so no pounding, maybe just some two-sided tape!

Are you sure it was original? Is the new switch wobbly? Putty sounds like a makeshift cure for someone breaking some plastic off the seat where it should sit firmly.

First one looks like speed pick-up(pitot) from the lower unit. Would go through rigging tube to dash gauge.

It might also be an indication that your sacrificial zincs in and around the engine have worn down to where they are no longer doing their job, accelerating corrosion on other aluminum parts.

Can you stick your phone under there and take pictures?

Great job, need more pictures! Did all four corners go up full height together, or did you have to work in steps?

I need that, if no one else has already asked. I will PM you the same.

If you are not sure whether they are 15° or 30°, lay three of them on a table top. Put the flange of the first one parallel to the edge of the table, and the flange of the next two perpendicular to the end of the preceding tube. You will end up with either a 45° angle from the table edge, or a...

I had pop outs in the splash well of my 93 tournament. In the automotive world, such stupidity would probably result in a factory recall, and a dealer replacement with screw ins. I drilled a small hole through the reinforcing rib on the bottom of the plate, and secured each one to something...

Is your trickle charger constant voltage, or is it a smart charger, which turns itself off when the battery is topped off?

"With light fuel and crew, you can hit 50MPH is relatively flat conditions with a burn of 1.0 -1.21 GPH as I recall........" If I were getting 40-50 MPG, I would be happy as a clam.

The V6 just came out this year, didn’t it? The link you were reading may have applied to the V8’s.

OEM part is probably half, but at $125/hr labor, it is not a 6.8 hour job. Post a copy of the invoice, if you go ahead with it.

V8, or the new V6? Talk to your insurance company, and get it in writing that your coverage will not be affected. Yamaha did not introduce a 350 until 2007, but your boat probably had max horsepower for the time. If weight and performance are not dramatically increased, they should give you the...

I think 14G is wire size.

What size are the tabs, and where are they mounted? Sometimes I see them way in board, right next to the motors, and I just don’t understand it.

If the bulb collapses, loosen the gas cap to see if the vent might be clogged.