Search results

We had similar results in Florida Keys. Spots we fished for years with no idea why they produced. Also found we could improve our positioning to be closer to the structure. Here is a comparison of the standard fishing chart compared to the shaded relief on a favorite patch reef spot.

I bought the NVUS007R Vision+ East (includes NJ) for $149. Previously updated Built-in Base maps for $99 and bought VUS006R Vision+ South (FL and Gulf) for $200 from Hodges.

Dennis - Life was so much simpler when we were young and knew it all!

Garmin bought Navionics a few years back. The cartography was merged into g3 Bluechart. Garmin is now shipping Garmin Navionics+ charts on new units. These charts look a little different and include 1 foot contours. The Garmin Navionics Vision+ also include shaded relief and satellite imagery...

Not sure how it applies to your unit. You need to check with Garmin and figure it out.

Garmin has the upgrades on sale for Bluechart g3 to the new Garmin Navionics+ and Vision+ charts. Built-in U.S. & Coastal Canada Built-in Chart Updates Garmin Navionics+™ | BUS001L. $149.99 >>> $99.99 ---- check your unit to see if you can replace basemaps. U.S. & Coastal Canada - Lakes...

13' 6" is what you will have on the interstate highways. Overpasses are usually more but this is safe. On other roads - State and local if you stick to the truck routes 13' 6" should be fine. I helped a friend ship a boat back from the Great Lakes area - hight was 13' but wide load - it was a...

Take the boat and trailer and have it weighed. You own it so no need to guess. Get a tongue weight too. May have to go to a trailer shop for this. Rent a UHaul if necessary. Note that they only equip trucks with 2" ball. They may not allow anything other than a UHaul trailer to be towed. I'm a...

Yep. Both of them!

Take the screws out of the tab. Work the trim tabs and measure the exposed part of the tab hydraulic ram. Hinge the trim tabs down and look for bending or debris.

I have a number of earlier panels fro my 1998 Islander. It's Sunbrella Navy. The fabric wears extremely well. My tonneau cover is 25 years old and could pass for new. https://www.sailrite.com/Sunbrella-6026-0000-Navy-60 Most enclosure fabricators have gone to Stamoid which I don't really...

Don't panic yet. You need to slow down and get better information to decide what is happening. Batteries are not wired in series. Series would give you 24 VDC. I can see from the photo the black ground wire between the two negative posts. The red positive wires go to the switch positions 1 and...

Maybe cut the deck out carefully and do glass work to create a hatch. Alternative is cut the deck or, replace tank and re-glass it back in.

Your battery wiring diagram would be helpful. I have seen some GW's wired where the second battery is just a spare and not connected and reversed when the a/b switch is flipped. I'm a little concerned that the engine isn't charging the battery while running. Make sure the engine is charging the...

I use the Melnor hose quick connects for my flush system. Unsnap, plug hose in and flush. I suppose you could remote them. The connection on the engine block is a dead end

That's probably a circuit breaker on the panel. Yes swap it for a 15 amp one. X-marks the spot for the positive (red) wire to the pump. The negative (black) goes to the ground buss bar. 12 gauge wire is good for 20 amps. If there is existing 14 gauge wiring in place to where you want it you...

That is how they do it on the big rigs! Nice clean look for the new electronics. I did a flush mount in a starboard insert. Looks good but re-glassing would have been better.

They put this coating on your hull, topside and your cushions?

This is a film applied like a wrap?

Consider a GemLux replacement latch. Ask if they sell replacement parts.