Search results

Could be some kind of Idle Air problem. Not familiar with the Yamaha..dunno if it has an IAC valve

Read the breaker. Its probably a 10A or 15A. They are readily available on amazon https://www.amazon.com/SEACHOICE-13131-Button-Circuit-Breaker/dp/B0002UENSS/ref=sr_1_10?crid=1JJDE7Q45VEQ8&keywords=15A+marine+breaker&qid=1700175352&sprefix=15a+marine+breaker,aps,99&sr=8-10 Or you can use a...

pix please

OK good. In that way, you tested both wires. If you used a battery ground, you would be bypassing the black wire. So no, you don't need to measure using the neg battery terminal. So the motor does not run when connected to both wires but you measure 12v with no pump connected and switch on...

That’s a wrap!

Well, based on your description, if there was a short (or an open) it would have be there regardless of the new pump. But.. You say without pump there is 12volt on wiring with switch on and 0 v with switch off. Are you measuring across the pair of wires or are you using a nearby ground? Did...

SS

the wire is stainless cable

Not sure what your model does but.. Cupholders and rodholders that are mounted in "blind" gunnels can have a drain tube to prevent water from being trapped on top of the foam that is outside the stringers. They can drain to a small outlet to the main deck or they can drain thru tubing all the...

Reactor 40 with Smartpumpv2 will handle anything. The Compact Reactor is the lighter duty model

You are repowering from Yamaha to Suzuki. The Zuke gauges are really well thought out stand alone gauges (once you learn all the menus) There is no need to use a Garmin or other MFD for most Engine data. The Garmin is a great way to display Range and remaining fuel, if you connect the tanks...

if its really tough. scrub with Soft Scrub bleach and leave it on and let it sit in the sun for an hour.

Update: the replacement AP pump (Smartpumpv2) ran well all season.

read this thread https://www.greatgrady.com/threads/265-express-suzuki-df200apxw2.29099/

The gunnel is plenty thick enough. Rod holders are thru bolted with big washers or a backing plate. I think the OP is asking about the connection of the 2 piece gunnel to the hull. On my 265 it was epoxied and screwed (minimal screws) and then caulked with something like 4200 ( I say 4200...

Got out yesterday. Plan was to try a last Seabass trip. Early morning there was a large fleet off the beach in Bay Head. Giant schools of bunker. Humpback feasting on them. So we stopped in there and snagged a couple bunker and sent them out. No striper bites, nobody near us catching. So we...

read this thread https://www.greatgrady.com/threads/groco-pump-simple-macerator-retrofit-265-express.19049/post-249220

Got skunked this afternoon outside Manasquan Inlet

The top gets hidden by the radar so you don’t really need the starboard. Fill the holes and re-drill I added a 4” mount to raise it higher than the bubble. By the book you don’t want it radiating through your electronics box. You could program a no radiate sector. I think most guy just...

Quick answer … Sand areas clean, clear packing tape bottom of holes, fill with thickened epoxy