Search results

My plan is to get an aftermarket hard top next year or the year after when funds allow.

Can I lower the Bimini Top with the inssenglass still attached to the frame of the Bimini Top? Unhook bottom and roll up glass? Thanks.

I measured the old letters and the the capital letter was 7 inches. I figured it would be close to the same but this new one is a bit bigger. I think you can see it from Texas when I splash it!

Put the new decals on today, came out pretty good. Have to chase a few bubbles, waiting for it to warm up a bit. Next up polish and wax the helm, cockpit and outside the walk around. The add all my gear and splash it! The only thing is the Forest Green in the boat name was a bit darker than I...

Nice job guys, I had an old 1987 Mako 17 with wood all over it, when finished it looked real nice.

I'm not a fiberglass expert but I would just put some Marine Tex in the chips, cracks, and transom and be done with it.

Man that seems expensive, you may want to ask over at the HULL TRUTH there may be a fabrication shop that does nice work in the area you're just not finding.

Penweld in Long Island I will be using, one of the other guys here has his top. Real nice. Maybe he can ship it.

So let me get this straight, I could use Marine Tex to fill in the gouge/scratch, then color match the gel coat to blend it in nice? I am a novice when it comes to fiberglass. You would use the color tint kit from Spectrum to do this? Anyone have a photo of a patch they did on their boat?

When I rent a place in LBI, I usually bring the boat. Had the Mako in Haglers for 2 weeks 2 years ago on our first ride out of the marina, my wife asked me if there are any sharks in the bay, not 30 seconds later a big fin swam by the boat!. I said I think we need a bigger boat!

I have a similar problem, I was thinking of using rubber cement.

The water fill for the freshwater tank is under the Port side Helm seat, Is this for the fresh water wash down AND sink or just for the wash down? What do you guys do fill it with a hose? Thanks.

What are you guys using for the gelcoat repair? I have a few spots I could do also.

Forget the arm rests replacements, do a search here, very expensive if you can find them. Someone used a small sock and it actually looked good. I believe the dealer has the striping. I just took mine all off and I'm replacing it with a different color. I ordered it from Boat US website. Good...

This was during our demo of s similar boat. Stranded Jet Skier. We went with a full aft cabin.

No thrusters ,we use the throttle. When we did the demo before we bought it, we pulled a jet ski right into the boat from the bow. It's pretty cool.

Yes, 1 1500 gallon per minute pump and 2 discharges. It has a bow door that lays flat and you can walk off it or drive an atv on it. We used it to put a brush fire out on Bannermans Island. Stretched handlines off the bow.

28 Foot Lake Assault Fire Boat. 1500GPM Pump and full CBRN cabin.

So I used an oxidizer, polish and wax today on the Starboard side. Put it on with a buffer and removed it by hand. Came out pretty good. Going to do Port side when I have a cloudy day. Also spray cushions with a 303 Fabric Guard and cleaned the teak foot rests. I ordered the new Striping, Boat...

Forgot Mako, the only Shepherd who likes playing with the hose. Tomorrow I am going to work on cleaning the cockpit, helm and bow.